Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1113 / 2536

SET-STATE-STS1 4 of 2 Page SET-STATE-STS1
nmon
report not Do monitored. not to state channel the Set
not Do channel. the for conditions status or alarm
is signal good a if in-service to state channel the change
the until state this in remain will channel The detected.
the until or command this with again changed is state
deleted. is channel this involving cross-connection
NOTE:
cross- STS-1 either is that channel STS-1 an that recommended is It
an or packs circuit MXRVO with equipped unit function a to connected
cross-connected VT1.5 is that channel STS-1
not
the in put be
nmon
state.
the in put is channel STS-1 an If
nmon
or
auto
command, this using state
the in put also are channel STS-1 specified the within channels VT1.5 the
nmon
or
auto
which for channels VT1.5 to only applies This state.
cross- are that channels VT1.5 example, (for defined are states channel
ring). a from dropped or interfaces DS1 to connected
of state primary a If
nmon
displayed: be will message following the entered, is
) s ( l e n n a h C * / s s e r d d a r o d e r o t i n o m e b t o n l l i w
/ * e t a t s s i h t n i d e m r a l a
of part is that channel STS-1 an is command the in specified address path the If
the with denied be will command the channel, cross-connected STS-3c an
message: following
S V N S
/ * e t a t S d i l a V n i t o N , s u t a t S * /
/ * . d e t c e n n o c - s s o r c y l r e p o r p t o n s i h t a p d e i f i c e p s e h T * /
OC-3 DDM-2000
2000 February 2 Issue
11-443