Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 2276 / 2536

363-206-285 Detailed Level Procedure:
DLP-532
Issue 2, February 2000 Page 10 of 14
DDM-2000 OC-3 M
ULTIPLEXER
Letter "d" or "P." in FE ID Display
19.
!
CAUTION:
If PC hard drive is being used, ensure you are in the correct directory. If
floppies are being used, ensure the first (number 1) diskette is installed in
floppy drive. Ensure PC is connected to the front CIT (CIT-1) connector.
Enter
term
or
term COMn
command, where
n
= 1 or 2. If
term
is entered
without the
COMn
option, then COM1 will be selected by default. Disregard
message
Can’t find script <init>
if you see it after starting the
terminal emulator.
Response: Two brief messages are printed and you are instructed to
Press any key to continue . . .
after the
second message. After you press any key, the terminal
emulator is loaded and the terminal responds as follows:
CTRM ready. (Type Alt-h for help.)
Communications established.
20. Unplug and reseat the SYSCTL and immediately push and hold the FE SEL
and UPD/INIT buttons at the same time until a P appears in the FE ID display
(takes approximately 15 seconds). The software download automatically
begins and may take 20 to 45 minutes.
Response: PC starts download and prints the following message:
Searching for optimal transfer rate.
Handshake established at <
baudrate
> baud
.
In progress . . . .
The dots continue to print until program installation is
complete. If using the floppy disks, insert each diskette
when prompted. After installation is completed, the PC
prints the following completion message:
ins-prog:TID COMPLD
/* Generic a.b.c is installed */
The SYSCTL resets and the terminal is logged off the
system.
21. Was response correct?
If YES, then continue with Step 22.
If NO, then proceed to Step 27.