Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1493 / 2536

NTP-018
: Circuit Order 363-206-285
Page 5 of 10 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
14.
NOTE:
If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must
also be enabled.
NOTE:
If Sync Autoreconfiguration is enabled at any line-timed
OC-3 node in a ring, it must be enabled at all line-timed
OC-3 nodes of a ring.
NOTE:
The
rtrv-sync:
command retrieves the
Synchronization Report
. This report displays the
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
Commands and Reports section of 363-206-285,
DDM-2000
OC-3 Multiplexer, TARP Release 13 and Later, User/Service
Manual—Volume I and 363-206-295, DDM-2000 OC-12
Multiplexer, TARP Release 7, User/Service Manual—Volume
I for a description of the
rtrv-sync:
command format.
Use the
rtrv-sync:
command to obtain the
Synchronization Report
and verify if Sync
Autoreconfiguration is enabled or disabled. Use the
set-sync:
command to enable or disable the Sync Autoreconfiguration
parameter, as required.
15.
NOTE:
Two or more shelves in the same network cannot have the
same system name or TID (set by the
set-ne:
command).
Verify no duplicate TID settings exist. The
rtrv-ne:
command
may be used at each shelf in the network to display settings. If
duplicates exist, determine new settings and use the
set-ne
command to make new settings.
16. What Release of software is installed in the system?
If Release 15 software is installed, continue with Step 17.
If Release 13 software is installed, proceed to Step 18.