Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1957 / 2536

TAP-107
: Trouble Clearing 363-206-285
Page 1 of 28 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
Clear Far End Alarm Using
Craft Interface Terminal (CIT)
1.
NOTE:
The Remote NE Status feature is valid starting with OC-3 Release 15.0
and must be enabled using the
rnestat
parameter of the
set-ne:
command.
NOTE:
It is assumed that a CIT is available and that there is a failure at a far end
node (as indicated by an FE ACTY LED on the local system or by the
Source Address
of
farend
in the local
Active Alarms and
Status Report
).
Connect the CIT to the connector on the User Panel or remote login to the
near-end system, if not already performed.
Reference: DLP-521
2.
NOTE:
The
Active Alarms and Status Report
is output automatically
following CIT log in. The report shown in Figure 1 is an example that
shows several entries. There may be only one entry in the actual report.
Note the information in the
Source Address
and
Description
columns for
the top entry/entries above the first single-dashed line in the
Active Alarms
and Status Report
(Figure 1) (for example,
MINOR farend MM-DD HH:MM:SS - SiteXNE1
)
Figure 1 – Example of Active Alarms and Status Report
/* Active Alarms and Status Report
=============================================================
Alarm Source Date Time Srv Description
Level Address Detected
=============================================================
MINOR farend MM-DD HH:MM:SS - SiteXNE1
MINOR farend MM-DD HH:MM:SS - SiteYNE1
-------------------------------------------------------------
ne-acty m1-1-1-1 MM-DD HH:MM:SS inc. VT AIS
*/
DLP-521