Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1112 / 2536

SET-STATE-STS1 4 of 1 Page SET-STATE-STS1
NAME
Channels STS-1 of State Set set-state-sts1:
FORMAT INPUT
set-state-sts1: Address:ps=PrimaryState
;
DESCRIPTION
off and on turn to used is It channels. STS-1 of states the sets command This
channels. specified for signals maintenance and failures signal of monitoring the
are: parameters input The
Address
are: addresses Valid channel(s). STS-1 the identifies Address
{a,b}-{1-2,all} {m,c}-{1-3,all}, all,
{a,b,c} all,
Addresses) (EC-1
{m,a,b,c}-{1,2,all} all,
Addresses) OLIU (27-type
{a,b,c}-1
Addresses) OLIU (26G2-U
with (starting 29-type or 24-type with equipped is shelf the If
valid slots, unit Main its in packs circuit OLIU 15.0) Release OC-3
are: Addresses unit Main
all,m-{1-12,all}
for: set be can states Channel
OC-3 (If OC-12 and OC-3, OC-1, within channels STS-1
unit Main in OLIUs 29G-U or 24G-U with equipped is shelf
or ELAN, DS3, to cross-connected are that interfaces slots)
interfaces DS1
ring OC-1 an from dropped are that channels STS-1
interface. DS1 or EC-1, ELAN, OC-3, an to interface
or OC-1 OC-3, an from dropped are that channels STS-1
unit Main the in 29-type) or (24-type interface ring OC-12
interface DS3 or DS1, ELAN, EC-1, OC-3, an to slots
or (24G-U OC-12 or OC-1 or OC-3 within channels STS-1
VT1.5 are that interfaces EC-1 or slots) unit Main in 29G-U
interfaces. DS1 or EC-1, OC-1, OC-3, to cross-connected
ps
the of one have may which state channel the is PrimaryState
values: following
auto
the Monitor automatic. to state channel the Set
conditions. status or alarm report not do but channel,
change automatically detected, is signal good a When
normal begin and in-service to state channel the
conditions. status and alarm of reporting
11-442
2000 February 2 Issue
OC-3 DDM-2000