Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 2127 / 2536

363-206-285 Detailed Level Procedure:
DLP-512
Issue 2, February 2000 Page 5 of 10
DDM-2000 OC-3 M
ULTIPLEXER
4. Set options using the syntax of the Commands and Reports section in this
manual.
5. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
Table A – DDM-2000 OC-3 Parameters Provisionable Via the CIT
Parameter Range
Default
(Note 1)
Command (Note 2)
Date current value 70-01-01
set-date
Time current value 00:00:00
set-date
Target ID (system name) 20 characters LT-DDM-2000
set-ne
Remote NE Status enabled,disabled
set-ne
Alarm Group 1-255 255
set-ne
Alarm Gateway NE yes,no no
set-ne
Shelf number 1-8 1
set-ne
Idle channel signal STS Uneqpd./AIS insert AIS
set-ne
VT Uneqpd./AIS insert AIS
CO/RT select CO, RT RT
set-ne
CIT page length 0 (pager off), 3-150 rows 24
set-link
PM thresholds See PM Table -
set-pmthres
Alarm holdoff delay 0-30 sec 2
set-attr-alm
Alarm clear delay 0-30 sec 15
set-attr-alm
Power minor almn. level MN, MJ MN
set-attr-alm
OC1 degrade threshold
10
-5
to 10
-9
10
-6
set-oc1
AIS almn. level of NSA OC-1
Line AIS
CR, MJ, MN, NA NA
set-oc1
OC3 degrade threshold
10
-5
to 10
-9
10
-6
set-oc3
Sync messaging K byte, S byte, disabled K byte
set-oc3
AIS almn. level of NSA OC-3
Line AIS
CR, MJ, MN, NA NA
set-oc3
DccMode distinct,identical distinct
set-oc3
Application 0x1,1+1 1+1
set-oc3
OC12 degrade threshold§§§
10
-5
to 10
-9
10
-6
set-oc12
Sync messaging§§§ K byte, S byte, disabled K byte
set-oc12
AIS almn. level of NSA OC-12
Line AIS§§§
CR, MJ, MN, NA NA
set-oc12
DccMode distinct,identical distinct
set-oc12
STS-1 path signal
degrade threshold†††
10
-5
to 10
-9
10
-6
set-sts1
Signal fail alarm threshold
10
-3
to 10
-6
10
-3
set-sts1
NSA STS-1 path AIS
alarm level
MN, NR MN
set-sts1
SA STS-1 path AIS
alarm level
CR, MN, NA, NR MN
set-sts1
STS-1 channel state*** NMON, AUTO‡ AUTO
set-state-sts1
OC-1 line state‡‡‡ NMON, IS IS
set-state-oc1
See notes and footnotes at end of table.