Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1098 / 2536

SET-SECU 7 of 2 Page SET-SECU
remote TL1 50 to up TL1, run to provisioned is port CIT a If
port. CIT that on created be can associations
1: NOTE
the command, this executing of result a as If
porttype
from/to changes value parameter’s
cit
to/from
tl1
any ,
terminated be will port specified the on session login active
and users Privileged including out logged user(s) the and
X.25 the provisioning for true is same The users. current
to port
synch
or
synch
.
2: NOTE
Once
cit-1/2
to set are ports
tl1
be to need they ,
to reprovisioned
cit
used be can program CIT the before
again.
(DTE port X2.5 asynchronous the to applies same The
type port X.25 the reprovision to have will user the Address);
be to
synch
provisioning (by
x25
and Address, for
synch
as used be can port X.25 the before Type) Port for
again. Synchronous
baudrate
are messages TL1 which in baudrate the Specifies
are: parameter this for values The received/transmitted.
1200
,
2400
,
4800
,
9600
and (Default),
19200
.
if only for, prompted is parameter This
porttype
has parameter
either of value the
tl1
or
asynch
.
NOTE:
the command, this executing of result a as If
baudrate
the on session login active any changes, value parameter’s
out; logged user(s) the and terminated be will port specified
users. current and users Privileged including
echo
back echoed be to needs entered character the whether Specifies
are: parameter this for values The not. or
enabled
or ,
disabled
is value default The .
enabled
.
if ONLY for, prompted is parameter This
porttype
parameter
of value the has
tl1
or
asynch
.
sec
in or disabled, enabled, is security whether determines Security
Enabling port(s). DCC and CIT specified the on state lockout
to pair password and login valid a enter to users requires security
DCC-all. or CIT specified the via system the access
11-428
2000 February 2 Issue
OC-3 DDM-2000