Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1137 / 2536

SET-T1 6 of 3 Page SET-T1
the if even end far the to transmitted is
AIS
to set is parameter
yes
circuit LAN IMA the to applicable not is parameter This .)
packs.
ais
be should AIS an whether determines AlarmIndicationSignal
DS1 incoming of loss a when fiber optical the towards inserted
are values The detected. is signal
yes
and
no
value default the ;
is
yes
the if ignored is parameter This .
bpv
(described parameter
to set is above)
yes
IMA the to applicable not is parameter This .
packs. circuit LAN
pmmd
DS1 the by supported ports for mode the sets parameter This
pack. circuit performance-monitoring
Pmmd
for used only is
the affect not does parameter this Setting performance-monitoring.
this later, and 13.0 Release OC-3 In signal. received or transmitted
pack circuit (BBG20) TMUX the to applicable be also will parameter
DSX) (from incoming the within signals DS1 internal the monitor to
values: following the of one be may parameter This signal. DS3
off
value) (default off turned PM DS1
on
BBF6, BBF3, is type CP if (only on turned PM DS1
BBG20). or BBF10 BBF9,
OC-3 DDM-2000
2000 February 2 Issue
11-467