Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1515 / 2536

NTP-022
: System Turnup 363-206-285
Page 3 of 8 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
4.
NOTE:
If Kbyte or Sbyte (sync messaging) is enabled for the
main-1
and
main-2
optical interfaces at any node in a ring,
it must be enabled at all nodes of the ring.
NOTE:
The
rtrv-oc3:
or
rtrv-oc12:
command retrieves the
OC-3 Line Provisioning Report
or
OC-12 Line
Provisioning Report
. This report displays the
provisioned configuration of OC-3 or OC-12 lines. See the
Commands and Reports section of this manual for a
description of the
rtrv-oc3:
or
rtrv-oc12:
command
format.
Use the
rtrv-oc3:
or
rtrv-oc12:
command to obtain the
OC-3 Line Provisioning Report
or
OC-12 Line Provisioning Report
and verify if Kbyte/Sbyte
is enabled or disabled. Use the
set-oc3:
or
set-oc12:
command to enable or disable the Kbyte/Sbyte parameter, as
required.
5.
NOTE:
If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must
also be enabled.
NOTE:
If Sync Autoreconfiguration is enabled at any line-timed node
in a ring, it must be enabled at all line-timed nodes of a ring.
NOTE:
The
rtrv-sync:
command retrieves the
Synchronization Report
. This report displays the
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
Commands and Reports section of this manual for a
description of the
rtrv-sync:
command format.
Use the
rtrv-sync:
command to obtain the
Synchronization Report
and verify if Sync
Autoreconfiguration is enabled or disabled. Use the
set-sync:
command to enable or disable the Sync Autoreconfiguration
parameter and to set sync source, as required.