Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 962 / 2536

RTRV-STATE-EQPT 7 of 4 Page RTRV-STATE-EQPT
switch. protection
active-rx
being signal the lines, OC-3 unit’s function the For
end near the by selected is line this on received
is transmitted being signal the but switch, protection
end. far the by selected not
active-?
line protection the lines, OC-3 unit’s function the For
the of state The direction. receive the in failed is
unknown; is direction transmit the in line protection
line protection the on transmitted signal the might be
end. far the by selected
standby
active. currently not is line optical or pack circuit The
equipped. not or applicable Not —
the connections, pass-through of because applications ring For
function For OLIUs. main both for active be always will state switch
drop, local hairpin path-protected pass-through, for provisioned units
for active be always will state switch the applications, ring 0x1 or
OLIUs. both
Priority Switch
Only request. switch protection active currently the is priority Switch
protection a cause can request switch protection priority higher a
this in priority switch the applications, ring For done. be to switch
to main the of switching equipment the to only applies report
the See signals. unit function
rtrv-state-path
for command
information. switching protection path
NOTE:
is Priority Switch the packs, protected 1+1 or 1X1 For
one for displayed Priority Switch The packs; both for displayed
other. the for displayed is pack
following: the of one be may priority Switch
inhibit
is switch the until done be will switches protection No
reset.
protection of lockout
the for pack protection the to access prevents This
group.
service of lockout
for pack circuit protection the to access prevents This
slot. service specified the
forced
until done be will switches manual or automatic No
reset. is switch forced the
11-292
2000 February 2 Issue
OC-3 DDM-2000