Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 2526 / 2536

363-206-285 Detailed Level Procedure:
DLP-566
Issue 2, February 2000 Page 2 of 4
DDM-2000 OC-3 M
ULTIPLEXER
3. Before beginning the software installation, refer to the Software Release
Description for the software being installed for a description of any special
considerations required when installing this version of the software.
4. NOTE:
If you are using a PC operating in a Windows
‡
environment, you must
exit
Windows and restart your PC in MS-DOS mode before performing
these download procedures. For example, if your PC is running Windows
95 you must exit Windows by clicking on the Start button, then Shut
Down, then Restart the computer in
MS-DOS mode.
Start MS-DOS operating system on the PC [DLP-534].
Response: PC displays the prompt (for example,
C>
,
C:\DOS>
)
determined by the PC.
5. If you are going to use the PC hard disk to load software to the shelf,
copy
all
files on the source diskettes(s) (floppies) to a directory on the hard disk (for
example, GEN_1301 for generic version 13.0.1).
6. If you are going to load the software from the hard disk, use the
cd
command
to change to the appropriate hard drive directory containing the software.
If you are going to load the software from the floppies, use the appropriate
MS-DOS command (for example,
a:
or
b:
) to go to the drive where the floppy
disk will be installed.
Response: PC displays the appropriate prompt (
A>
,
B>
,
C>
,
C:\DOS>
, etc.) determined by the PC.
Comment: If you are using floppies and get a disk error message,
verify the drive latch is locked and that you have the
proper diskette installed in the drive.
7. NOTE:
The new generic program may be on many floppy disks. If you are using
the floppy disks, the PC will prompt you to insert disks as needed after
the first disk is installed.
If you are using the floppy disks, insert the first (number 1) floppy disk into the
PC drive.
‡ Registered trademark of Microsoft Corporation.