Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1173 / 2536

SWITCH-SYNC 4 of 2 Page SWITCH-SYNC
reset
the allow will This switch. manual active any Clear
to back switch to system
External
or
LineTimed
mode non-revertive for provisioned is system the if
to switched manually been has it if or switching
mode. holdover
manual
mode, timing provisioned the from Switch
External
or
LineTimed
The mode. holdover to ,
switch the until mode holdover in remain will system
reset. is
of value SyncFunction a For
src
( priority the ,
pri
is: value )
manual
the to SynchronizationSource active the from Switch
source. standby
valid a not is OLIU OC-1 an with equipped slot any 9.0, and 8.0 Releases For
never will switch source synchonization manual a Thus, source. synchronization
OLIU. OC-1 an with slot a select
when source synchronization valid a is OLIU 27-type a 9.1, Release with Starting
source synchronization the as used is #1 line OC-1 FN-C. not but slot, Main a in
case. a such in
of equippage the to due completed be can switch source synchronization no If
message: following the with denied be will command the sources, alternate the
T W Q E
/ * e p y T g n o r W , e g a p i u Q E * /
/ * d e p p i u q e y l r e p o r p m i s e c r u o s c n y s e t a n r e t l A * /
with executed is command this If
Priority=inhibit
with or
SyncFunction=mode
until disabled be will switching protection automatic then ,
with and SyncFunction same the with again executed is command this
Priority=reset
.
OC-3 DDM-2000
2000 February 2 Issue
11-503