Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1608 / 2536

363-206-285 Circuit Order:
NTP-030
Issue 2, February 2000 Page 6 of 8
DDM-2000 OC-3 M
ULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
16.
NOTE:
Shelves that are part of a subnetwork being partitioned into
multiple areas require that the NSAP
AREA
field and level 2
IS-IS routing parameters of the
ent-ulsdcc-l3:
command be set. See Section 11, Commands and Reports
in 363-206-285,
DDM-2000 OC-3 Multiplexer, TARP Release
13 and Later, User/Service Manual—Volume I, for an
explanation of the command parameters and 824-102-144,
Lucent Technologies 2000 Product Family, Operations
Interworking Guide For TARP Releases, for an explanation
of the engineering rules for subnetwork partitioning.
Use the
ent-ulsdcc-l3:
command to designate the
NSAP
AREA
field and level 2 IS-IS routing, as required.
17.
NOTE:
If Kbyte or Sbyte (sync messaging) is enabled for the
main-1
and
main-2
optical interfaces at any node in a ring,
it must be enabled at all nodes of the ring.
NOTE:
The
rtrv-oc3:
command retrieves the
OC-3 Line Provisioning Report
. This report displays
the provisioned configuration of OC-3 lines. See the
Commands and Reports section of this manual for a
description of the
rtrv-oc3:
command format.
Use the
rtrv-oc3:
command to obtain the
OC-3 Line Provisioning Report
and verify if Kbyte/Sbyte
is enabled or disabled. Use the
set-oc3:
command to enable or
disable the Kbyte/Sbyte parameter, as required.