Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1768 / 2536

NTP-048
: System Turnup 363-206-285
Page 8 of 12 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
At the DDM-2000 shelf, use the
ent-ulsdcc-l3:
command to
designate the NSAP
AREA
field and level 2 IS-IS routing, as
required.
At the FT-2000 shelf, use the
CONFIGURATION-Set-ULSDCC-L3
command to designate the
L3 Area address and Level 2 IS parameters, as required.
20.
NOTE:
The
rtrv-pm-line:
command in the following procedure
displays performance monitoring data associated with the
OC-3 or OC-12 lines terminated on the system.
DLP-515 Perform end-to-end OC-3 or OC-12 line test.
21. Repeat this procedure from Step 16 for all OC-3 or OC-12 optical
spans until the OC-3 or OC-12 ring is complete to the other host
FT-2000 shelf.
22.
NOTE:
Establishing service requires that the proper slots in each
terminating node be properly equipped with the correct
circuit pack(s) for the type of service being established. It
also requires numerous cross connections in each of the
nodes representing the path of the required service.
Additionally, transmission tests should be performed to verify
the continuity and quality of the established circuit.
The dual-homed DDM-2000 OC-3 or OC-12 access network is
now ready for initial service to be established. For service
terminations on a FT-2000 shelf, use the procedures in
365-575-103,
FT-2000 OC-48 Lightwave System, Release 8.1
Through 9.1, User/Service Manual, to establish those services.
For DS1, DS3, EC-1, T1, HDSL, STS3c, and/or LAN terminations
on a DDM-2000 OC-3 shelf, use the procedures in this
User/Service manual to establish those services.
DLP-515