Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1577 / 2536

NTP-028
: System Turnup 363-206-285
Page 3 of 6 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
7.
NOTE:
The
rtrv-t1:
command retrieves the
T1 Port
Provisioning Report
. This report lists information
about each IMA LAN port. This information includes
attributes set by the
set-t1:
command. See the
Commands and Reports section of this manual for a
description of the
rtrv-t1:
command format.
At each LAN terminating node, use the
rtrv-t1:
command to
obtain the
T1 Port Provisioning Report
and verify the
hardware and software option settings.
8. Install 177A Retainer Cards into all unused service slots.
9. At each LAN terminating node, use the
set-t1:
and
set-lan:
command to set the characteristics of the LAN port and protocols
of the circuit being established. See the Commands and Reports
section of Volume I of this manual for an explanation of these
commands.
10. At each LAN terminating node, make the appropriate cable
connection(s) to the DS1/DS3 cross-connect point(s) or
equivalent connection points for the circuit being established.
11. Verify that no LEDs or alarms are activated. If any LEDs or alarms
are activated, refer to Trouble Clearing: IXL-001 and follow the
appropriate trouble-clearing procedure.
12. If one of the terminating ends is equipped with DS1 or TMUX
circuit packs for a DS1 or DS3 interface to support services being
established, establish initial DS1 (NTP-004) or DS3-to-DS1
(NTP-020) service.