Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1503 / 2536

NTP-020
: System Turnup 363-206-285
Page 3 of 8 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
4.
NOTE:
The
rtrv-t3:
command retrieves the
T3 Port
Provisioning Report
. This report lists information
about each DS3 port. This information includes attributes set
by the
set-t3:
command. See the Commands and
Reports section of this manual for a description of the
rtrv-t3:
command format.
Use the
rtrv-t3:
command to obtain the
T3 Port
Provisioning Report
and verify the software option settings.
5.
NOTE:
DS1 circuit packs cannot be installed in a group that is
equipped with TMUX circuit packs.
DLP-513 Verify the line build out (LBO) option jumpers are installed as
required and reinstall TMUX circuit pack(s).
6. Make the appropriate cable connection(s) to the DS3
cross-connect point(s) or equivalent connection point(s) for the
circuit being added.
7. At the DS1 terminating node(s) of the circuit being established,
determine which DS1 port(s) is to be put into service and what
options are to be selected.
8.
NOTE:
The
rtrv-t1:
command retrieves the
T1 Port
Provisioning Report
. This report lists information
about each DS1 port. This information includes attributes
set by the
set-t1:
command. See the Commands and
Reports section of this manual for a description of the
rtrv-t1:
command format.
At each DS1 terminating node, use the
rtrv-t1:
command to
obtain the
T1 Port Provisioning Report
and verify the
hardware and software option settings.
DLP-513