Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1142 / 2536

SET-T3 7 of 2 Page SET-T3
ais
should AIS DS3 a not or whether determines AlarmIndicationSignal
be may value The inserted. be
yes
or
no
not is parameter This .
13.0 Release (OC-3 pack circuit TMUX BBG20 the to applicable
to set is AIS When later). and
yes
:
an of detection upon DSX-3 the towards inserted is AIS DS3 —
fiber. the from incoming AIS path STS or signal of loss OC-3
DS3 of detection upon fiber the towards inserted is AIS DS3 —
DSX-3. the from incoming LOS
NOTE:
is mode removal monitor violation the if inserted always is AIS
for provisioned
vmr
or
vm
.
NOTE:
If
md
to set was value
vmr
or
vm
to set is it and ,
cc
AIS the
to defaults always
off
value.
alm
Failure Signal DS3 incoming an for level alarm the sets AlarmLevel
following: the of one be may and
cr
Alarm Critical
mj
Alarm Major
mn
Alarm Minor
na
Alarm No
for provisioned is system the If critical. is level alarm default The
LED ACTY NE the condition, loss-of-signal a is there and alarm no
the on LED fault the and illuminated, be will panel user the on
alarm the in reported be will condition The flash. will pack circuit
activity. end near a as report status and
later), and 13.0 Release (OC-3 pack circuit TMUX BBG20 the For
incoming three following the to applicable be will parameter this
signal and (OOF), out-of-frame LOS, alarms: DSX) (from DS3
BER. failure
11-472
2000 February 2 Issue
OC-3 DDM-2000