Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 705 / 2536

CNVT-CRS 5 of 2 Page CNVT-CRS
are: parameters input The
Address1
and
Address2
channels STS-1 two the of addresses the are These
be will and cross-connected currently are that
cross-connections. VT1.5 28 to converted
Addresses: STS-1 Valid
{a,b,c},
{a,b}-{1-2} {m,c}-{1-3},
in OLIU 29-type or 24- with equipped is shelf the If
are: addresses STS-1 valid the units, Main its
c-{1-3} {a,b}-{1,2}, {a,b,c}, m-{1-12},
NOTE:
cross-connections VT1.5 28 convert to available is capability inverse No
user the this, achieve to order In cross-connection. STS-1 single a to back
the using cross-connections VT1.5 28 the of each delete must
dlt-crs-vt1
using cross-connection STS-1 the enter then and command
the
ent-crs-sts1
command.
the by set mode, cross-connect the if systems, linear In
set-ne
has command,
following the with denied be will command this of execution default, of value a
message: denial
S V N S
/ * e t a t S d i l a V n i t o N , s u t a t S * /
/ * . s n o i t c e n n o c - s s o r c t l u a f e d r o f d e n o i s i v o r p m e t s y S * /
Address1
and
Address2
or cross-connection STS-1 existing an match must
message: following the with denied be will command the of execution
S V N S
/ * e t a t S d i l a V n i t o N , s u t a t S * /
/ * . t s i x e t o n s e o d n o i t c e n n o c - s s o r c 1 - S T S d e i f i c e p s e h T * /
OC-3 DDM-2000
2000 February 2 Issue
11-35