Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1022 / 2536

SET-ATTR-ALM 2 of 1 Page SET-ATTR-ALM
NAME
Attribute Alarm Set set-attr-alm:
FORMAT INPUT
set-attr-alm
[:
almdel= AlarmDelay
][
,clrdel= ClearDelay
][
,pmn= PMN
];
DESCRIPTION
delays. clear and holdoff alarm the sets command This
are: parameters input The
almdel
failures. equipment and signal incoming for delay the is AlarmDelay
an before present is condition fault a that time of interval an sets It
a with 30, and 0 between seconds, in is delay The declared. is alarm
2. of value default
NOTE:
interval recovery the exceeded, is threshold degrade signal a If
the than longer be may condition degrade signal the for
For result. will alarm an and delay, holdoff provisioned
20 of delay alarm an with interface OC-3 an suppose example,
10 of threshold degrade signal a and seconds
-6
signal a has
a for interval recovery the Since seconds. 10 of failure degrade
10
-6
the of length total the seconds, 15 is threshold rate error
of seconds 15 plus failure of seconds (10 condition alarm
20 of delay alarm provisioned the exceed will recovery)
declared. be will alarm an and seconds,
clrdel
be to declared be can alarm an before time in delay the is ClearDelay
and AIS (including failures signal and failures equipment For clear.
failure alarm the when begins interval time delay clear the FERF),
30 and 0 between is delay the failures, equipment For clears.
clear failures, signal For seconds. 15 of value default a with seconds,
seconds. 15 at fixed is delay
pmn
( minor either be can which level, alarm Minor Power the is PMN
MN
)
( major or
MJ
Minor. is default The ).
11-352
2000 February 2 Issue
OC-3 DDM-2000