Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1183 / 2536

TEST-TRMSN-T1 5 of 1 Page TEST-TRMSN-T1
NAME
T1 Transmission Test test-trmsn-t1:
FORMAT INPUT
test-trmsn-t1: Address:[dirn=Direction][,dur=Duration]
;
DESCRIPTION
!
CAUTION:
the causes command This service. affect will command this of Execution
DEMUX or MUX the in channel selected the on signal test a of insertion
channel. selected the on service affect will and direction
pack circuit LAN IMA the to applicable not is command This
port. DS1 low-speed a for test transmission automated an up sets command This
"internal" an for test transmission automated an up set also will command This
later. and 13.0 Release OC-3 in pack circuit (BBG20) TMUX the within port DS1
errors. bit for checks system the which pattern repetitive a is signal test The
tested be not may channels multiple time; each tested is channel one Only
be must signal the executed, is command this Before simultaneously.
loopback a of presence the for checks DDM-2000 back. looped appropriately
warning a return will system the exists, loopback no If test. the beginning before
test. the peforming before message
maintenance. for and equipment new of installation for used is command This
are: parameters input The
Address
port. DS1 the of Address
Addresses: Valid
{a,b,c}-{1-7}-{1-4}
supports 15.0) Release (OC-3 pack circuit (BBF6) T1EXT The
port only BBF6, a on ports addressing When ports. T1 two
valid. are 2 and 1 numbers
dirn
the has parameter This test. transmission the of Direction
values: following
mux
(towards direction MUX the in inserted is signal test The
the is This 11-13. Figure in shown as fiber) optical the
parameter. this for default
demux
direction DEMUX the in inserted is signal test The
11-14. Figure in shown as DSX) the (towards
OC-3 DDM-2000
2000 February 2 Issue
11-513