Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1059 / 2536

SET-OC3 6 of 1 Page SET-OC3
NAME
Characteristics OC-3 Set set-oc3:
FORMAT INPUT
set-oc3
:
Address
[:
dgr= SignalDegradeThreshold
]
[,
syncmsg= SynchronizationMessaging
][,
aisalm= Alarm
];
set-oc3
:
Address
[:
dgr= SignalDegradeThreshold
]
[,
syncmsg= SynchronizationMessaging
][,
aisalm= Alarm
,
dcc= DccMode
][,
app= Application
];
later) and 15.0 Release (OC-3
DESCRIPTION
line OC-3 specified a of (parameters) characteristics several sets command This
the topology, linear a in shelf OC-3 an to refers address the If pair. line or
slots. FN and Main for pair line a as expressed is address
is Main for address the topology, ring a in shelf OC-3 an to refers address the If
line a as expressed is it slots FN for and main-2), or (main-1 line as expressed
pair.
are: parameters input The
Address
pair(s). line or line(s) OC-3 the identifies Address
Addresses: Linear OC-3 Valid
fn-{a,b,c,all} main,
Addresses: Ring OC-3 Valid
main-{1,2,all},
all fn-{a,b,c,all},
later) and 15.0 Release for valid (not
NOTE:
with (starting 29G-U or 24-type with equipped is shelf the If
its of slots both in packs circuit OLIU 15.0) Release OC-3
to belong will addresses valid OC-3 only the unit, Main
units. function
dgr
as threshold degrade signal the specifies SignalDegradeThreshold
threshold this When 10. base the to logarithm a of terms in BER a
protection automatic and raised be will alarm an crossed, is
this of value The initiated. be will line service the of switching
-6. is value default The -5. to -9 of range a has parameter
main-1 of addresses for value degrade signal the releases, ring For
main-2 and
must
signal to change any Therefore, same. the be
by other the to made be automatically will address one for degrade
software. the
syncmsg
a in reconfigured be to timing allows messaging Synchronization
of one has parameter This failure. fiber or node a upon network
values: following the
OC-3 DDM-2000
2000 February 2 Issue
11-389