Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1057 / 2536

SET-OC1 2 of 1 Page SET-OC1
NAME
Characteristics OC-1 Set set-oc1:
FORMAT INPUT
set-oc1
:
Address
[:
dgr= SignalDegradeThreshold
]
[,
aisalm= Alarm
];
DESCRIPTION
line. OC-1 specified a of (parameters) characteristics the sets command This
are: parameters input The
Address
line(s). OC-1 the identifies Address
OLIUs): 27-type (for Addresses OC-1 Valid
main-all, all,
fn-{a,b,c}-{1,2}-{1,2}, fn-all, main-{1,2}-{1,2},
fn-{a,b,c}-all
OLIUs): 26G2-U (for Addresses OC-1 Valid
fn-all,
fn-{a,b,c}-all fn-{a,b,c}-{1,2}-1,
dgr
as threshold degrade signal the specifies SignalDegradeThreshold
threshold this When 10. base the to logarithm a of terms in BER a
has parameter this of value The raised. be will alarm an crossed, is
-6. is value default The -5. to -9 of range a
NOTE:
OC-1 each of addresses both for value degrade signal The
pair line must signal to change any Therefore, same. the be
the to made be automatically will address one for degrade
software. the by other
aisalm
affecting nonservice the of level alarm provisioned the is Alarm
values: following the has and AIS line OC-1 (NSA)
cr
alarm Critical
mj
alarm Major
mn
alarm Minor
na
(default). reported but alarmed, Not
OC-3 DDM-2000
2000 February 2 Issue
11-387