Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 815 / 2536

OPR-LPBK-EC1 OPR-LPBK-EC1
DDM-2000 OC-3 Issue 3 June 2001 11-145
The input parameters are:
If a slot is determined to have the wrong circuit pack type for the command, the following
message is displayed:
If the command cannot be completed due to hardware problems on the SYSCTL, the
following message is displayed:
If an invalid address is entered, the following message is displayed:
When input, this command will cause the following confirmation message to be
displayed:
RELATED COMMANDS
rls-lpbk-ec1
Address
Address of EC-1 port(s) to be looped back.
Valid EC-1 Port Address:
{a, b, c, all}
lpbktype
loopbacktype specifies whether the loopback is terminal or facility
terminal
Terminal loopback directed towards the high-speed
facility. This is a default value.
facility
Facility loopback directed towards the DSX.
/*
Address
not equipped for STS1E */
/* Enter low-speed EC-1 port address: {a, b, c, all} */
/* SYSCTL failed - no loopback established */
/* Invalid Address */
/* Enter EC1 port address: {a, b, c, all} */
/* Caution! Execution of this command may affect service. You
have selected the opr-lpbk-ec1 command with these parameters:
Loopbacktype
=loopbacktype
Address=
address
*/
Execute? (y/n or CANcel/DELete to quit) =
Page 2 of 2