Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1958 / 2536

363-206-285 Trouble Clearing:
TAP-107
Issue 2, February 2000 Page 2 of 28
DDM-2000 OC-3 M
ULTIPLEXER
3.
NOTE:
Far-end alarm or status conditions are listed in this report with a
Source
Address
of
farend
. Local alarm or status conditions have a
Source
Address
of the local slot, line, port, channel, path, cross-connection, or
operations interface (DCC, TL1 (X.25), TBOS, etc.) where the event
occurred. (See
Addresses in the Commands and Reports section of this
manual.) Use the
rtrv-alm:
command to get another report, if
necessary.
Does the
Source Address
of any top entry above the first single-dashed line
in the alarm report indicate a local alarm?
If YES, then continue with Step 4.
If NO, then proceed to Step 6.
4. Find the
Alarm Level
for the local alarm in Table A and go to the indicated
procedure.
5. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
6. Use the
rtrv-nmap
/
rtrv-map-network
command to get a network map
report.
Table A – Trouble Conditions
Alarm Level TAP
CRITICAL TAP-101
MAJOR TAP-102
MINOR TAP-112
ne-acty TAP-117
PWR MINOR (PMN) TAP-104
abnormal (ABN) TAP-109