Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1053 / 2536

SET-NE 5 of 2 Page SET-NE
!
CAUTION:
the Changing
TID
to NE this to logins TL1 active all cause will
activated be to have will NE this to logins TL1 New dropped. be
value. TID new the using
rnestat
15.0. Release OC-3 with starting valid is parameter This
of value a have can (feature) Status NE Remote
enabled
or
disabled
of value a has parameter this If .
enabled
will user the ,
for prompted be
almgrp
and
agne
other the as well as ,
for prompted be not will user the otherwise parameters;
almgrp
and
agne
.
almgrp
15.0. Release OC-3 with starting valid is parameter This
of value numeric a has (AG) Group Alarm
1
through
255
in NEs All .
AG same the have that not, or nearby whether subnetwork, the
will AG the of members All group. same the of members are number
of NEs with not but other each with information Status NE share
is DDM-2000 for number AG default The Groups. alarm different
255
desired. is AG single a if changed be to have not may and
agne
15.0. Release OC-3 with starting valid is parameter This
of value a has NE) Gateway (Alarm AGNE
yes
or
no
which ,
element. network gateway alarm an is system this whether indicates
is parameter this for value default The
no
is AGNE one least At .
message the support to group alarm each for needed
alarms, office activity, (FE features Status NE for communications
Any status). panel user FE and ACO local discretes, miscellaneous
be may some but AGNE an be can group alarm the of member
near location or subnetwork the in position their of because preferred
be may group alarm same the of NEs Other center. maintenance a
each in NE one least At required. if AGNEs backup as provisioned
an as designated be must group alarm
agne
Elements Network .
(If alarms failure" communication "AGNE raise can AGNE an without
enabled). is feature status NE remote the
shelf
bay a in system the of (1-8) identification numeric the is Shelf
CIT local the by used is parameter Shelf The site. a at arrangement
default The CIT. the to connect to system which identify to interface
1. is value
idle
Unequipped or AIS an not or whether determines IdleChannelSignal
STS-1 and VT1.5 in line SONET the toward inserted be should signal
the of one be may value The cross-connected. not are that channels
following:
ais
line SONET the towards inserted is AIS VT1.5 or STS-1
the if STS1Es) and (OLIUs interfaces SONET from
is slot low-speed a if or cross-connected not is channel
cross- STS-1 is unit function the but equipped not
connected.
OC-3 DDM-2000
2000 February 2 Issue
11-383