Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 818 / 2536

OPR-LPBK-T1 5 of 3 Page OPR-LPBK-T1
lpbktype
facility. or terminal is loopback the whether specifies Loopbacktype
are: parameter this for values valid The
terminal
high-speed the towards directed loopback Terminal
value. default a is This facility.
facility
the For DSX. the towards directed loopback Facility
of operation packs, circuit BBF3 and BBF1B, BBF1,
to signals DS1 incoming four all causes loopback the
DSX. the towards back looped be
15.0) Release (OC-3 pack circuit (BBF6) T1EXT The
a on ports addressing When ports. T1 two supports
Specifying valid. are 2 and 1 number ports only BBF6,
all
only. 2 and 1 ports selects
facility DS1 individual later, and 13.0 Release In
DS1 28 the of one each for supported is loopback
each for or pack circuit TMUX BBG20 the on signals
pack. circuit (DS1PM) BBF3B a on DS1 four the of
denial following the address, the with consistent not is type loopback the If
displayed: is message
S V N S
/ * e t a t S d i l a V n i t o N , s u t a t S * /
/ * . s s e r d d a e h t h t i w t n e t s i s n o c t o n s i e p y t k c a b p o o l * /
circuit the on problems hardware to due completed be cannot command the If
displayed: is message following the pack,
* / e m a n P C s s e r d d A / * d e l i a f P C
Address
and
CPname
pack circuit provisioned and address slot the to refer
respectively. slot, the for type
11-148
2000 February 2 Issue
OC-3 DDM-2000