Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 2124 / 2536

DLP-512
: Detailed Level Procedure 363-206-285
Page 2 of 10 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
set-attr-env
Names and sets alarm level of miscellaneous discrete
input points at RT only.
set-attr-cont
Names miscellaneous discrete control output points at
RT only.
set-date
Sets date and time.
set-fecom
Enables or disables far end communication
(DCC/LAN) over the data communication channel and
sets Network Side/User Side parameters.
set-lgn
Enters, edits, and deletes logins and passwords.
Privileged users can change other users’ passwords
by using this command.
set-link
Sets length of page output on the CIT.
set-ne
Sets the name [Target Identifier (TID)] of the network
element. Designates a shelf as an alarm gateway
network element (AGNE) and sets alarm group
numbers. Designates the Shelf numbers and
designates the Central Office/Remote Terminal
parameter. Sets the Idle Channel Signal parameter.
set-passwd
Sets or changes a users’ password. All users can
change their own passwords.
set-pmthres-line
Sets the thresholds of the line performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-pmthres-sect
Sets the thresholds of the section performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-pmthres-t1
Sets the thresholds of the DS1 performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-pmthres-t3
Sets the thresholds of the DS3 performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-pmthres-sts1
Sets the STS-1 path performance parameter
thresholds. Available only in Release 2 or later
software.