Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1110 / 2536

SET-STATE-OC3 2 of 1 Page SET-STATE-OC3
NAME
State Line OC-3 Set set-state-oc3:
FORMAT INPUT
set-state-oc3: Address:ps=PrimaryState
;
DESCRIPTION
used is command This lines. OC-3 more or one of state the sets command This
line. specified a from failures signal of monitoring the off and on turn to
are: parameters input The
Address
line(s). OC-3 the identifies Address
addresses: Valid
fn-{a,b,c}-{1,2,all} fn-all, main-{1,2,all},
ps
following the of one have may which state line the is PrimaryState
values:
nmon
alarm report not Do monitored. not to state line the Set
line and Section line. the for conditions status or
stopped be will collection data monitoring performance
if in-service to state line the change not Do state. this in
this in remain will line The detected. is signal good a
this with again changed is state the until state
in reported and monitored still is status DCC command.
the DCC, disable To state. this
set-fecom
command
used. is
is
the at signal good for monitored be to state line the Set
and conditions, status alarm, of Reporting line. specified
state. normal in is data PMON
of state line a If
nmon
displayed: be will message following the entered, is
) s ( e n i L * / s s e r d d a n i d e m r a l a r o d e r o t i n o m e b t o n l l i w
/ * e t a t s s i h t
11-440
2000 February 2 Issue
OC-3 DDM-2000