Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 741 / 2536

ENT-CRS-STS1 16 of 6 Page ENT-CRS-STS1
the when established is cross-connection DS3 0x1 A
BBG19 two or one contains unit function addressed
STS-1 addressed the case, this In packs. circuit
to connected is Main-1 in OLIU the by received channel
and unit function addressed the of 1 slot in port DS3 the
is Main-2 in OLIU the by received STS-1 addressed the
addressed the of 2 slot in port DS3 the to connected
be may slots function the of One unit. function
and 15.0 Release OC-3 with starting Also unequipped.
0X1 a if slots, Fn in OLIUs 22-type using when
the provisioning requires this desired, is application
the using type application 0X1 with ) interface(s OC-3
set-oc3 command.
dc
ring dual support cross-connections continue and Drop
continue and Drop applications. interworking
address unit function the if allowed only are connections
low-speed OLIU 22-type or STS1E the with equipped is
packs. circuit
the cross-connection, pass-through a indicate addresses the If
to set automatically is but for prompted not is CrsType
twoway
The .
of CrsType a that indicates message confirmation
twoway
been has
than other CrsType a If user. the for selected
twoway
on entered is
pass-through a indicate addresses the when line command the
not is CrsType the If rejected. is request the cross-connection,
locked
or
dc
in displayed not is and requested not is RingId the ,
not is CrsType the If messages. confirmation
locked
or
dc
and ,
RingId. for entered value any ignore will system the entered, is RingId
ring
ring the is RingId releases. ring all with available is parameter This
connections. locked or continue and drop for identification
For
dc
be will rotation ring which specifies it connections, type
valid The element. network this at dropped as well as continued
are: values
m1
Ring
m1
OLIU Main-1 the on received is that ring the is
OLIU. Main-2 the on transmitted is and
m2
Ring
m2
OLIU Main-2 the on received is that ring the is
OLIU. Main-1 the on transmitted is and
cross- manual or default the into placed be may shelves releases, linear In
the using mode connect
set-ne
is mode cross-connect no If command.
mapping fixed a provides which mode, default in be will shelf each specified,
STS-1s the and signal line OC-3 the in embedded signals STS-1 between
cross- manual the When shelf. the on terminating signals with associated
user. the by changed be may map cross-connect the selected, is mode connect
this with user the by entered be must cross-connections All
ent-crs-sts1
command.
OC-3 DDM-2000
2000 February 2 Issue
11-71