Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1035 / 2536

SET-FECOM 5 of 1 Page SET-FECOM
NAME
Communications Far-End Set set-fecom:
FORMAT INPUT
set-fecom: Address
[:
com= Communications
][,
nsus= NS/US
]
[,
lanreset= lanreset
];
DESCRIPTION
data section the over communication disables or enables command This
overhead embedded an is DCC A LAN. IAO or (DCC) channels communication
communications end-to-end for used line SONET the in channel communications
information status and control, alarm, carries DCC The maintenance. and
(NEs). elements network between
NOTE:
only. users privileged to available is command This
is it if successfully complete will command this 13.0, Release with Starting
session. login remote a during executed
are: parameters input The
Address
LAN. IAO or DCC the of address the identifies Address
Addresses: DCC Linear Valid
dcc-{m,a,b,c,all}
releases ring later and R15.0 OC-3 to apply also addresses These
DCC "identical" the for provisioned is interface ring main the when
mode.
Addresses: DCC Ring Valid
dcc-{m1,m2,a,b,c,all}
OLIU): 27-type (for Addresses DCC OC-1 Valid
dcc-all,
dcc-{m,a,b,c}{1,2}-{1,2}
Address: LAN IAO Valid
lan
later) and 13.0 (Release
com
specified a over communication whether indicates parameter This
TARP later and 13.0 Release OC-3 (for interface LAN IAO or DCC
are values valid The disabled. or enabled is releases)
enabled
or
disabled
is value default The .
enabled
.
( port’s LAN IAO the 15.0, Release OC-3 with Starting
address=
lan
)
for value default com is
disabled
.
DCC, specific DCC-all, per enabled/disabled be must Communication
point, some at example, an As DCC. specific or LAN. IAO or
might LAN IAO the and channels DCC some over communication
enable to order In time. same the at enabled be to have
this interface, LAN IAO and channel DCC a both over communication
enable to once twice; executed be to have will command
enable to time other the and DCC, a over communication
OC-3 DDM-2000
2000 February 2 Issue
11-365