Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 2279 / 2536

DLP-532
: Detailed Level Procedure 363-206-285
Page 13 of 14 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
30. If the download starts and fails during its progress, exit term (Alt-F2) and then
restart a new term session.
31. Unplug and reseat the SYSCTL and immediately push and hold the FE SEL
and UPD/INIT buttons at the same time until a P appears in the FE ID display
(takes approximately 15 seconds).
If the download still does not complete, refer to Trouble Clearing: TAP-116.
32. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
33. Use the
rtrv-alm:
command to display alarm and status information.
34. Does status message
dormant/exec code mismatch
appear in the report
for this shelf?
If NO, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If YES, then continue with Step 35.
35. NOTE:
The software you downloaded has been loaded as a dormant copy in this
shelf. The original software is still the executing software. The
apply:
command must be used at this shelf to install the dormant copy of
software as an executing copy. When the
apply:
command is executed
during an upgrade from Release 9.1, there is 30-minute delay before the
dormant copy installation begins.
When the
apply:
command is executed during an upgrade from
Release 11.0 or later, if you do not specify a
time
and
date
parameter,
there is a default 15-minute delay before the dormant copy installation
begins. Once the installation begins, the dormant copy is installed in
approximately 10 minutes.
See the Commands and Reports section of Volume 1 of this manual for a
description of the
apply:
command. The
apply:
command allows you
to coordinate the software download across the network.
Are you going to use the
apply:
command at this time to install the dormant
version of software?
If YES, then continue with Step 36.
If NO, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
TAP-116