Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 882 / 2536

RTRV-MAP-NETWORK 4 of 3 Page RTRV-MAP-NETWORK
Type Product
DDM-2000 example, (for NE local the of type product the is This
OC-3).
IS 2 Level
Level default the is NE listed the whether identifies column This
"Y" by indicated be will this IS, 2 Level a is NE local If IS. 2
blank The ". " or "Y" are: values Possible column. this under
Release FiberReach NE). 1 (Level IS 2 non-Level a indicates
ISs. 2 Level as provisioned be cannot NEs 3.0
NSAP
required address (40-character) 20-byte a is address NSAP The
network OSI the within identification unique provide to OSI by
pre- are which of some fields, of number a of consists and
of structure The user-settable. are which of some and defined
display. following the in shown is NSAP the
Structure NSAP
SEL Sys. Area RD RES Organization DFI IDI IDI AFI NSAP
Field: Ident. ID PAD
1 6 2 2 2 3 1 2 1 Bytes:
00 none 0000 0000 0000 000000 80 F 840 39 Default
Value:
(hex)
not user not
provisionable provisionable provisionable
the to refer fields, individual NSAP’s the on information more For
ent-ulsdcc
page. command
by separated address NSAP the up make that fields different the lists report The
space. single a
they subnetwork, same the in found were TIDs duplicate have that NEs some If
report. the in reported be both will
this while report this run to were user the if and isolated, becomes NE an If
only report; the in listed be longer no would NE isolated the exists, still condition
listed. are NE local the by reachable are that NEs
1: NOTE
the in NE other any at provisioned been have Addresses Area Multiple If
is NE remote a for translation NSAP-to-TID TARP a and area, NE’s local
information the list only will report this completed, successfully
NE’s remote A NE. remote the of NSAP primary the to corresponding
an to responds NE remote the which for NSAP the is NSAP primary
query. TARP NSAP-to-TID
11-212
2000 February 2 Issue
OC-3 DDM-2000