Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1837 / 2536

NTP-055
: System Turnup 363-206-285
Page 5 of 10 Issue 2, February 2000
DDM-2000 OC-3 M
ULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
11.
NOTE:
If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must
also be enabled.
NOTE:
If Sync Autoreconfiguration is enabled at any line-timed
OC-3 node in a ring, it must be enabled at all line-timed
OC-3 nodes of a ring.
NOTE:
The
rtrv-sync:
command retrieves the
Synchronization Report
. This report displays the
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
Commands and Reports section of 363-206-285,
DDM-2000
OC-3 Multiplexer, TARP Release 13 and Later, User/Service
Manual—Volume I) for a description of the
rtrv-sync:
command format.
Use the
rtrv-sync:
command to obtain the
Synchronization Report
and verify if Sync
Autoreconfiguration is enabled or disabled. Use the
set-sync:
command to enable or disable the Sync Autoreconfiguration
parameter, as required.
12.
NOTE:
Two or more shelves in the same network cannot have the
same system name or TID (set by the
set-ne:
command).
Verify no duplicate TID settings exist. The
rtrv-ne:
command
may be used at each shelf in the network to display settings. If
duplicates exist, determine new settings and use the
set-ne
command to make new settings.