Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 742 / 2536

ENT-CRS-STS1 16 of 7 Page ENT-CRS-STS1
between correspondence one-to-one a is there cross-connections, STS-1 For
one-to- a also is There number. slot low-speed the and number Group VT the
number. port speed low the and number VT the between correspondence one
following the on listed are addresses cross-connection manual and default Valid
user the cross-connection, any perform successfully To pages.
must
the equip
additional For packs. circuit OLIU 27-type or 21G, 21D, 22-type, with slots Main
"Cross-Connection the to refer cross-connections, on restrictions and examples
8. Chapter in located information Provisioning"
Addresses: Cross-Connect Release Linear Default
a to m-1
or STS1E, DS3, with equipped is A group function when Default
packs circuit MXRVO
b to m-2
or STS1E, DS3, with equipped is B group function when Default
packs circuit MXRVO
c to m-3
or STS1E, DS3, with equipped is C group function when Default
packs circuit MXRVO
a-1 to m-1
circuit OLIU with equipped is A group function when Default
packs
b-2 to m-2
circuit OLIU with equipped is B group function when Default
packs
c-3 to m-3
circuit OLIU with equipped is C group function when Default
packs
cross- the if entered be may cross-connections manual OC-3, DDM-2000 For
( manual to set is mode connect
crs= manual
the by provisioned as ),
set-ne
items Where below. listed are cross-connections manual Valid command.
form to used be may items these of one) only (and one any }, { braces in appear
address. the
11-72
2000 February 2 Issue
OC-3 DDM-2000