LiuGong CLG835H, Service Manual

Page: 406 / 764

4-134
Removal and Installation
January 24, 2017
Work hydraulic system CLG835H
3. Hold the bucket cylinder with
lifting rope and traveling
crane;
Lifting rope;
2T\4410lb
traveling crane
4. Loosen the hose plate bolt
connected with the steel
pipe of the small cavity oil
port of the bucket cylinder,
and remove the hose
assembly and shield the
hose joint.
Open-end
wrench: 13mm
5. Loosen the hose plate bolt
connected with the steel
pipe of the big cavity oil port
of the bucket cylinder and
remove the hose assembly
and shield hose joint.
Open-end
wrench: 13mm
6. Remove the fastening bolt of
the front and rear pin shaft
of the bucket cylinder and
knock out the pin shaft with
a copper bar;
Copper bar;
Open-end
wrench: 15mm
7. Lift out the bucket cylinder
from the frame to place it on
a level ground.
Lifting rope;
2T\4410lb
traveling crane
8. Remove the bolts tightening
the steel pipe clamp and
steel pipe of big cavity of the
bucket cylinder and remove
the steel pipe; check
whether the O-ring is aged
or damaged and replace it in
time, mask the oil ports of
steel pipe.
Open-end
wrench: 13mm
Inner hexagon
wrench: 6mm,
8mm
9. Mask the big and small cav-
ity oil ports of the bucket cyl-
inder to avoid pollution. Shielding film
Figures Operation instruction Tools
P18H00177
P18H00178
P18H00179
P18H00180