Modbus/TCP – Communication protocol 95
6
Modbus/TCP –
Communication protocol
Contents of this chapter
This chapter describes the Modbus/TCP communication protocol
for the adapter module.
Modbus/TCP
Modbus/TCP is a variant of the Modbus family of simple, vendor
neutral communication protocols intended for supervision and
control of automation equipment. Specifically, it covers the use of
Modbus messaging over TCP connection on an IP network.
The FENA adapter module acts as a Modbus/TCP server with
support for the ABB Drives and Transparent profiles. The adapter
module also supports Modbus over UDP. The only difference
between Modbus/TCP and Modbus/UDP is that in Modbus/UDP
the transport layer protocol is UDP instead of TCP.
The supported Modbus commands are listed in section
Function
codes
on page
96
. Two simultaneous Modbus/TCP connections
are supported, that is, two clients can be connected to the adapter
module at a time.
Further information on the Modbus/TCP protocol is available at
www.modbus.org
.
Summary of Contents for FENA-01
