Trumpf LASERCELL 1005, Руководство оператора

Страница: 100 / 645

2-38
Installation conditions TLC 1000 and TLC 1005 - Version 5
B337EN02.DOC
Working range
Dimension A [mm]
X = 1250 X = 2000 X = 3000 X = 4000
Dimension B [mm] 5020 5770 6830 8530
Total length of transport unit for basic machine
The basic machine can be transported to the installation site using
a gantry crane, crane truck, or armored rollers. The basic machine
and units are first positioned next to the actual installation site.
Danger
The center of gravity of the transport unit for the basic
machine is close to the front edge of the machine body!
The machine body can tip over if not transported properly.
This could lead to severe bodily injury or even death as well
as substantial damage to property.
½
Rotational moving device, position 4, fig. 32509 must fit closely
to stop, position C.
½
During transport, no persons are allowed in the danger zone.
For transport on armored rollers:
1. Position hydraulic hoisting jacks at the front and rear of the
machine body. Raise all four hydraulic hoisting jacks
simultaneously. Lift hydraulic hoisting jack evenly.
2. Arrange the armored rollers, positions 5 and 6, and the
rotational moving device, position 4, under the machine body
as shown in figure 32509.
3. Lower hydraulic hoisting jacks simultaneously.
4. Slowly move machine body to the installation site.
For transport using gantry crane or crane truck:
1. Attach the cross beam to the swivel bearers, positions 1 and 2
(4x), figure 32509 on the machine body in such a way that the
chains hang vertically and are arranged symmetrically.
2. Move the basic machine to the installation site using a crane
truck or gantry crane.
Table 2-27
Transporting basic machine
to installation site