Trumpf LASERCELL 1005, Руководство оператора

Страница: 447 / 645

5-34
Adjustment work on the welding head
B337EN05.DOC
7. Slip the welding head onto the B/C angular gear and tighten
the screws hand-tight.
8. Install the welding head identification connector. Connect the
welding gas, Crossjet and cooling water.
9. Select a welding head (refer to the sections "Selecting the
processing optics", "Selecting the welding head").
When switching the technology from welding to cutting:
10. Change the gas and air connection at the Z center sleeve
(refer to the section "Changing the gas and air connection at
the Z center sleeve").
6.2 Centering the beam
The beam must be re-centered:
•
Each time after adjusting the mode or beam.
•
After cleaning or replacing the parabolic mirror.
The CP_TAPESHOT.LST service program is used to trigger a
laser pulse.
Additional equipment, tools, material
•
Measuring magnifier (10 to 20 times enlargement).
•
Adhesive strips (Scotch Magic transparent film).
•
CP_TAPESHOT.LST service program.
1. Stick an adhesive strip onto the nozzle.
2. Position the welding head in jog mode at about the center of
the working area.
3. Select the CP_TAPESHOT program.
4. Press START PROGRAM.
A dialog box is opened.
5. Select Focal length.
6. If needed: edit start position.
If the laser output or pulsing time is to be edited:
7. Press Modify parameter.
8. Press Pulsing.
9. The laser pulse is triggered in the B90 position.
10. Check the fusion penetration on the adhesive strip with the
magnifying glass.
If the beam is off-center:
11. Adjust the beam.
Localizing the beam