Trumpf LASERCELL 1005, Руководство оператора

Страница: 461 / 645

5-48
Adjustment work on the welding head
B337EN05.DOC
The focus position f=0 is determined in the welding-through
process. The Deviation from nominal dimension is determined.
The CP_FOCUS_WELD program is used to weld eleven 40 mm
welding seams, each with a different focus position. After each
weld seam, the nozzle distance is increased by 1 mm. The process
starts with a nozzle distance of 10 mm.
Prerequisite
•
The welding head is fully mounted.
•
A nominal dimension of 4 mm is set at the welding head.
•
The beam is centered.
•
Clean nozzle in mint condition.
Additional equipment, tools, material
•
A flat, oil-free, 4 mm thick sheet, 600 mm x 150 mm, St37.
•
Gauge block 10 mm and 15 mm.
•
Utility program CP_FOCUS_WELD.
Note
The sheet must lie completely flat on the support and is not
permitted to warp during the welding sequence (the sheet should
possibly be tightened).
1. Select >Operation >Set-up > Service.
2. Set the "Head change" switch element to ACTIVE.
The selection dialog is started.
3. Work through selection dialog for mounted welding optics.
4. Select >Operation >Set-up >MDA.
5. Enter B0 C0.
6. Press Start.
The B and C axes travel to 0°.
7. Position the welding head 10 mm over a flat sheet. Use a
gauge block to check.
8. Note absolute position of the Z axis.
9. Select >Operation >Production >General welding table.
10. Select Table 1111. Edit the parameters if necessary.
11. Select the program CP_FOCUS_WELD.
Starting the approximate
search