Trumpf LASERCELL 1005, Руководство оператора

Страница: 426 / 645

B337EN05.DOC
Selecting processing optics
5-13
4. Selecting processing optics
Each time the processing optics are replaced, the control system
must be notified which processing optics are active, in order for
the corresponding joint offset values to be entered in the machine
parameters. The processing optics are selected interactively.
Note
The joint offset values can be edited in the selection dialog as
required. If, however, the value entered here does not
correspond to the actual joint offset of the processing optics,
there will be a collision with the workpiece. The axis motion will
not correspond to the programmed path.
When the "Head change" switch element is selected, an
identification dialog will only be started if the joint offset values
entered in the machine parameter differ from the joint offset values
in data management.
"Laser head identification" mask
1. Select optics and focal length.
2. Press Adopt.
The joint offset values entered in the dialog are adopted.
3. Press Close.
The dialog box is closed. The valid joint offset is transferred to
the data management.
4. Select >Operation >Set-up >Service again.
5. Set the "Head change" switch element to ACTIVE.
For further information on operation refer to the section "Selecting
the cutting head" or Selecting the welding head.
Identifying the processing
optics
Fig. 36077en