Trumpf LASERCELL 1005, Руководство оператора

Страница: 418 / 645

B337EN05.DOC
Overview of setting work
5-5
2. Overview of setting work
The setting work listed in the following may be carried out by the
operator. All work is executed in normal mode of the machine.
The safety devices of the machine are active.
The service programs listed here are stored on the hard disk of the
PCU 50 at the operator’s panel under:
C:\DH\TOPSMANU.DIR\SERVICE.PRG\CUSTOMER
Valid:
As of software update V05.10 and later.
For service program version V04.20.00 or later
Setting work Complete file When?
Checking the position of the B
and C axes and determining the
reference offset value At start-up.
When required.
After every collision.
Selecting processing optics Every time the processing optics
are changed.
Determining the joint offset of
the X and Y axes:
Cutting head
Welding head
CP_OFFSET_CUT.LST
CP_OFFSET_WELD.LST
At start-up.
After installing new processing
optics for which the joint offset
has not been determined.
Determining the joint offset of
the Z axis (tool length) After each change of the
processing optics.
Before installing the Teach
probe.
Calibrating the measuring probe CP_TOUCHPROBE.LST Each time after installing the
measuring probe, but before
beginning machining.
Changing the gas and air
connection at the Z center
sleeve After switching from welding to
cutting or vice-versa
Cutting head
Aligning the beam centrally to
the nozzle CP_TAPESHOT.LST After cleaning or changing the
lens.
After adjusting the mode or the
beam
Determining the focus position CP_FOCUS_CUT.LST After cleaning or changing the
lens.
After adjusting the mode or the
beam
Recording the DIAS
characteristic curve After switching on the machine.
After installing the cutting head.
After replacing the nozzle. After
maintenance work on the
distance control system