Trumpf LASERCELL 1005, Руководство оператора

Страница: 481 / 645

5-68
Determining the joint offset
B337EN05.DOC
Prerequisite
•
B and C axes are set exactly.
•
The cutting head is fully installed.
•
The beam is centered.
•
The focus position has been determined and set.
•
The DIAS characteristic curve has been recorded.
Additional equipment, tools, material
•
Micrometer or slide gauge.
•
2.5 mm thick sheet, ca. 500 mm x 500 mm, mild steel.
•
CP_OFFSET_CUT.LST service program.
1. Select cutting head:
–
Select >Operation >Set-up > Service.
–
Set the "Head change" switch element to ACTIVE.
–
Execute the selection dialog.
2. Position cutting head over sheet at a nozzle distance of
approx. 5 mm, observing start position.
3. Select CP_OFFSET_CUT program.
4. Press START PROGRAM.
A dialog box appears.
5. Select the focal length.
Warning
The axes travel directly to the entered start position
immediately. Risk of collision in the working area of the
machine!
Considerable damage to property.
½
Observe the start position.
½
Edit the start position if necessary.
6. If needed: edit start position.
7. Press Start.
The sample is cut (seven rectangles each with different C axis
positions C0, C90, C180, C270). A mask is opened after the
end of the program.
8. Measure dimensions A1, B1, C1 and D1.
9. Enter the dimensions A1, B1, C1 and D1 in [mm] into the
corresponding input fields.
10. Press Adopt.
The determined joint offset values are saved to the data manage-
ment.