Trumpf LASERCELL 1005, Руководство оператора

Страница: 444 / 645

B337EN05.DOC
Cutting head setting work
5-31
Prerequisite
•
The cutting head has been fully installed and selected via the
head change dialog.
•
The beam is centered.
•
The DIAS characteristic curve has been recorded.
•
Setting value on the scale is set to -3 mm or -5 mm.
•
Clean nozzle in mint condition with a diameter of 2.3 mm.
Additional equipment, tools, material
•
Flat sheet approx. 500 mm x 500 mm, 1 mm thick, stainless
steel (1.4301).
•
Feeler gauge 0.3 mm for cutting head 5".
•
0.4 mm thickness gauge for 7.5" cutting head.
•
CP_FOCUS_CUT.LST service program.
1. Close the door.
2. Position the cutting head above the sheet.
3. Activate the CP_FOCUS_CUT program.
4. Press START PROGRAM.
A dialog box is opened.
To call up the online help:
5. Press Note.
6. Select focal length.
7. Press Start.
The program is started at the current position. The reference
part is cut and engraved.
8. Use a thickness gauge to check every single kerf, starting at
both sides. Mark or make a note of the engraved value at
which the thickness gauge jams.
The average value between the top and the bottom marked value
defines the exact focus position f=0. This value is the adjustment
value.