Trumpf LASERCELL 1005, Руководство оператора

Страница: 142 / 645

B337EN03.DOC
The modules of the laser cutting center
3-35
Central lubrication
The central lubrication supplies the pinions of the X, Y, and Z
drives and the guide bearings of the axes with low-viscosity
grease.
The lubrication cycles for the X, Y, Z, B, and C axes are activated
by the control system every 12 operating hours (default lubricant
application). A lubrication cycle dialog is started at the end of the
current or next machining program if the control system realizes
that a lubrication cycle is necessary.
The Z axis is additionally supplied with grease automatically after
90 minutes of axis motion (default lubricant application). The
grease is sprayed onto the pinion of the Z axis and distributed on
the rack the next time the axis is moved.
The lubrication cycle and the lubrication cycle of the Z axis can be
called up at any time via Operation >Setup >Switch elements
>Service (refer to "Calling up the lubrication cycle" in the section
"Operating the machine" in the Operation chapter).
The TC_LUBRQ cycle is used to call up and immediately start a
lubrication cycle automatically in endless programs. The
TC_LUBRQ cycle has to be programmed by the user in the
NC program.
In order to reduce the risk of the Z center sleeve colliding with
objects in the machine’s workspace, for example with a tall work
table, the travel paths of the X, Y, and Z axes can be configured on
the machine as required – but only by TRUMPF service personnel.
The filling level of the low-viscosity grease reservoir is monitored
by the control system. A message is issued if the low-viscosity
grease reservoir has to be topped up.
Caution
Empty low-viscosity grease reservoir
Air enters the lubrication line, and the machine comes to a
standstill.
½
The lubricant reservoir must never be empty.
Lubrication cycle
Z axis
lubrication cycle
Calling up the
lubrication cycle
Lubrication cycle in endless
programs
Configuring the
lubrication cycle
Low-viscosity grease
reservoir