ASP STERRAD 100, Руководство по обслуживанию

Страница: 41 / 309

Introduction
The STERRAD
®
100 Sterilizer and the STERRAD
100 S
Sterilizer have
many similar messages. However, because of the differences in cycle
parameters, the STERRAD 100 S system has a number of messages that
are unique to its functions.
The messages are listed here in alphabetical order. Many of the
messages are preceded by an LED display “Cycle Canceled Please Wait”
or “Cycle Canceled Please Wait . . . 10 Min.” Those displays are not
shown here because they are so common. Instead the written messages
associated with the “Cycle Canceled” messages are reproduced here.
Messages in all capital letters are those displayed on the LED. If there is
also a written message, it is shown below the displayed message.
Messages in upper and lower case letters are usually written messages
accompanying the Cycle Canceled display.
Using System Messages
Messages with þ next to them are exclusive to STERRAD 100 S systems.
IMPORTANT!:
Your first step when troubleshooting a system is to verify
that the system is
properly connected to the power source
, and to
make sure all the
subsystems are properly connected to the AC
system and all circuit breakers are on and functioning normally. Once
you have verified these things, proceed with your troubleshooting steps.
Be sure to check the topics at the end of the message list. These topics
contain conditions that may not generate an error message but result in
other obvious problems.
XXX Cycles, remove cassette box
Problem/Condition
The maximum number of cassettes have been captured in the cassette
collection box.
Action
The box is full. Remove it and replace it with a new one.
System Messages Introduction
3-2 STERRAD® 100 Sterilizer ASP Service Guide rev D