ZENworks Control Center
1
19
n
ov
do
cx (e
n)
16
Ap
ril 20
10
1
ZENworks Control Center
You use ZENworks
®
Control Center to configure system settings and perform management tasks in
your Management Zone.
ZENworks Control Center is installed on all ZENworks Servers in the Management Zone. You can
perform all management tasks on any ZENworks Server.
Section 1.1, “Accessing ZENworks Control Center,” on page 19
Section 1.2, “Accessing ZENworks Control Center through Novell iManager,” on page 20
Section 1.3, “Navigating ZENworks Control Center,” on page 21
Section 1.4, “Changing the Default Login Disable Values,” on page 22
Section 1.5, “Changing the Timeout Value for ZENworks Control Center,” on page 22
Section 1.6, “Using the Config.xml File to Modify ZENworks Control Center Settings,” on
page 23
Section 1.7, “Bookmarking ZENworks Control Center Locations,” on page 24
Section 1.8, “Troubleshooting ZENworks Control Center,” on page 25
1.1 Accessing ZENworks Control Center
1
Using a Web browser that meets the requirements listed in “
Administration Browser
Requirements
” in the
ZENworks 10 Configuration Management Installation Guide
, enter the
following URL:
https://
ZENworks_Server_Address:port
Replace
ZENworks_Server_Address
with the IP address or DNS name of the ZENworks
Server. You only need to specify the
port
if you are not using one of the default ports (80 or
443). ZENworks Control Center requires an HTTPS connection; HTTP requests are redirected
to HTTPS.
The login dialog box is displayed.
2
In the
Username
field, type
Administrator
(the default) or an administrator name that you
previously created
in ZENworks Control Center.
