software (
cpy-mem
), takes approximately 10 minutes. The
second part, the reset of the shelf and the automatic
apply/activation of the downloaded software (
apply
), takes
approximately 5 minutes.
While the transfer is in progress, the following Progress
Indicator appears.
If you receive an error stating that FTP is not enabled, click
OK
.
Exit the Initial Software download wizard and proceed to
“Procedure 6-3.9: Log in serially and enable FTP and/or OSI on
the LAN port” (6-134)
............................................................................................................................................................
7
Do you wish to observe the FTP download progress?
If...
Then...
Yes
Proceed to
and then
continue with
No
Continue with
............................................................................................................................................................
8
After the download is complete, a completion message appears. Click
OK
.
Procedure 6-3.5: Initial software generic
installation via FTP (2.1 boot code)
Supporting procedures
....................................................................................................................................................................................................................................
6 - 1 0 2
Lucent Technologies
365-372-333 R2.1
Issue 4, June 2005