............................................................................................................................................................
5
On Screen 4, click
Finish
.
Result:
A warning message appears that lists the
information you provisioned in the previous screens. Verify
that the information is correct and click
Yes
. Note: The
download source directory is generics/dmxplore/2.1.x/p.
The initial software download is a two-part process, totalling
approximately 22 minutes. The first part, FTAM download of
the software (
cpy-mem
), takes approximately 12 minutes. The
second part, the reset of the shelf and the automatic
apply/activation of the downloaded software (
apply
), takes
approximately 10 minutes.
While the transfer is in progress, the following Progress
Indicator appears.
............................................................................................................................................................
6
After the FTAM download is complete, a completion message
appears. Click
OK
.
Result:
The second part of the initial software download
begins, the reset of the shelf and the apply/activation of the
downloaded software (
apply
).
During the automatic reset and the apply, the SYSCTL circuit
pack cycles through a series of changes in the LEDs’ state:
•
MN/ABN
LED extinguishes
•
MN/ABN
LED and
ACO/TST
LED simultaneously light for
approximately 12 seconds and then extinguish
•
MN/ABN
LED and
ACO/TST
LED simultaneously light for
approximately 8 seconds and then extinguish
Procedure 6-3.2: Initial software generic
installation via FTAM (2.0 boot code)
Supporting procedures
....................................................................................................................................................................................................................................
365-372-333 R2.1
Issue 4, June 2005
Lucent Technologies
6 - 6 5
