Result:
A warning message appears that lists the
information you provisioned in the previous screens. Verify
that the information is correct and click
Yes
. Note: The
download source directory is generics/dmxplore/2.1.x/p.
The initial software download is a two-part process, totalling
approximately 15 minutes. The first part, FTAM download of
the software (
cpy-mem
), takes approximately 5 minutes. The
second part, the reset of the shelf and the automatic
apply/activation of the downloaded software (
apply
), takes
approximately 10 minutes.
While the transfer is in progress, the following Progress
Indicator appears.
............................................................................................................................................................
7
After the FTAM download is complete, a completion message
appears. Click
OK
.
Result:
The second part of the initial software download
begins, the reset of the shelf and the apply/activation of the
downloaded software (
apply
).
During the automatic reset and the apply, the SYSCTL circuit
pack cycles through a series of changes in the LEDs’ state:
•
MN/ABN
LED extinguishes
•
MN/ABN
LED and
ACO/TST
LED simultaneously light for
approximately 12 seconds and then extinguish
•
MN/ABN
LED and
ACO/TST
LED simultaneously light for
approximately 8 seconds and then extinguish
•
CR/MJ
LED flashes eleven times
•
All LEDs remain extinguished; the reset is complete.
Procedure 6-3.1: Initial software generic
installation via FTAM (2.1 or later boot
code)
Supporting procedures
....................................................................................................................................................................................................................................
6 - 5 6
Lucent Technologies
365-372-333 R2.1
Issue 4, June 2005
