Multifors 2 - Parallel Bench-top Bioreactor
Preparations for Use
28 March 2018
Page
141
of
211
7.2.10 Attaching the Pump Heads to the Vessel Holder and Support Frame
The pump heads must be removed from the basic unit and at-
tached to the vessel holder and support frame. Proceed as follows:
Procedure
1.
Pull off and remove the cover plate from the pump heads.
NOTICE!
The cover plate serves only as a protective device
in operating mode. It is not heat proof and therefore
it may not be sterilised.
2.
Pull the mounting plate with the pump heads off the motor
drive shafts on the basic unit.
3.
Fit the mounting plate with the pump heads into the bottom
part of the vessel holder and support frame.
